|
| Repairing a Leaky Shower | Tracking down the origin of water seepage requires systematic detective work. In this matter, the proprietor was puzzled by a seepage that became visible only when the shower stall was employed. First of all we should detect where the seepage could be running from and afterward we will have to troubleshoot the situation. We would like to offer you to get to know our investigation.
 First, we inspected the drain by clogging it with a used dishcloth and at that time filling the place with water brought from another resource (not from the shower itself). We left it for a couple of hours. In that case, the investigation suggested that the shower tray and sieve weren't seeping.
Continuing the examination, we defined that the seepage maybe wasn't in the water feed lines. This is because indications of the seepage became visible only now and then—when feed lines are damaged the seepage is incessant.
The following place we inspected was the shower valve and its escutcheon.
In order to search for seepages in this place, peep at the plastic cap on the head of the shower handle. Underneath this cap you would find a bolt. Take off the bolt. (It would be great to wrap the shower drain with a dishcloth while doing this. That should guard surfaces from being worn through by your shoes and keep little elements such as bolts from falling down into the drain if you let one go down.)
After that, take off the two bolts keeping the escutcheon against the shower wall. Raise the escutcheon off and examine the reverse side. In that case, we supposed that the washer was spoiled during setting up.
To insulate the escutcheon, take away the old washer and change it for a fat snake of plumber's putty—but don't make an unbroken circle. You should remain a spot open at the base edge of the escutcheon to give drainage for fear that any water ever comes inside.
Place the escutcheon back into site, fix the bolts, and remove the putty that presses out. Mount the shower handle again.
Another origin of seepage in a shower area is the junction between the shower surround and the wall. If the old filler looks spoiled or if you see holes, take off all the filler with a putty knife. Be cautious as you operate to steer clear of scraping the shower surround or the wall surface. Clean down the place to take off bits of wastes.
At this time gasket the area with silicone filler once again. Filler that matches typical fixture colors is broadly offered. Run a bead of filler into the junction area, after that at once make flat the joint with a wet shred. This also drives the filler into the joint for a good seal.
A last site to inspect for supposed seepages is where the shower arm enters the wall.
Apply a strap spanner to unbolt the shower arm from its joining within the wall. Cleanse the threaded end of the arm if required; afterward enfold a couple of turns of Teflon joint tape around the threads. Constantly enfold joint tape in a counterclockwise way over the threads so that it won't come untwisted as you bolt the tube back into location.
Mount the shower head and arm again. Confirm the escutcheon is even against the wall. Turn on the shower and test for seepages one more time.
|
|
